Installation Instructions

Electrical Connection (cont.)

Connecting Conduit to the Range

warning

Do not connect the green appliance wire to the neutral (white) supply wire unless local building codes permit.

1.Remove the range electrical access cover from the back of the range.

2.IMPORTANT: If using a 4-wire connection, loosen the grounding screw and remove the neutral to ground jumper link from the terminal block. Leave the link in place for 3-wire connections.

Terminal block

Remove link on 4-wire installations

3.Remove the nut from the conduit strain relief (not included).

4.Slide the wires and the end of the strain relief into the hole on the bottom of the range electrical box.

5.Before connecting the wires, slide the strain relief nut over the wires and thread it onto the conduit strain relief inside the box. Tighten into place.

6.Connect the white wire to the neutral terminal in the box.

7.Connect the black wire to the L1 power supply terminal.

8.Connect the red wire to the L2 power supply terminal.

9.If using a 4-wire connection, connect the green wire to the grounding screw inside the box.

Bare wire connections

Loop and spade terminal connections

L1 terminal

Neutral terminal

L2 terminal

Neutral to ground jumper link removed

Grounding screw Red wire

Green wire White wire

Black wire

Conduit strain relief nut

4-Wire Conduit

Connection

(preferred)

L1 terminal

Neutral terminal

Neutral to ground jumper link

L2 terminal

Black wire

White wire

Red wire

10. Replace the range electrical access cover.

Conduit strain

 

 

relief nut

3-Wire Conduit Connection -

Where Local Code Permits

16