Installation Instructions
Re-installing the Oven Door
warning
To avoid personal injury or damage to the door from it falling off its hinges:
•Make sure that the notch on the bottom of each hinge rests on top of the lower lip of each hinge receptacle before attempting to open the oven door.
•Rotate the hinge locks toward the front of the range immediately after installation of the door.
1.Grasp the oven door on opposite sides and hold it at a 15° angle from the front of the oven. Slide the hinges into the hinge openings, resting the bottom of the hinge arms on the hinge receptacles. Continue to hold the door at a 15° angle with one hand while pushing in on each of the bottom corners of the door. Push until the notch on the bottom of each hinge slips over the lower lip of each hinge receptacle.
2.Lower the door to the fully opened position.
3.Rotate the two hinge locks toward the oven.
4.Slowly and carefully open and close the door completely to ensure that it is properly installed.
5.Remove any packaging from inside the oven.
Cooktop Assembly
warning
Never attempt to operate the range’s cooktop with any of the burner rings, burner caps or grates removed.
1.Remove the burner rings, burner caps and grates from their shipping packages.
2.Assemble the burners and grates as shown below.
Grates
SimmerSear Spill tray | Standard |
burners | |
burner |
|
|
| Ridge on bottom of |
|
|
| on inner burner cap |
|
|
| Inner burner |
|
|
| cap |
|
|
| Outer burner | Ridge on |
|
| bottom of | |
|
| cap | burner cap |
Notch on bottom | Lower lip | Burner | Igniter |
of hinge | of hinge | ring | |
| receptacle |
| hole |
|
| Burner | |
|
|
| |
Door Installation |
|
| ring |
|
|
| |
|
|
| Igniter on |
|
|
| burner base |
Pin on burner
base
SimmerSear Burner | Standard Burner |
Assembly | Assembly |
19