Dacor Electrical Requirements, (Models numbers ending with -C), Electrical Requirements (All models except those ending with -C), NEMA 14-50PPlug, NEMA 10-50PPlug

Planning the Installation

warning

IMPORTANT: Observe all governing codes and ordinances during planning and installation. Contact your local building department for further information.

Electrical Requirements (All models except those ending with -C)

It is the owner’s responsibility to ensure that a licensed electrician performs the installation of the electrical supply for this appliance. The electrical installation, including minimum supply wire size, must comply with the National Electric Code ANSI/NFPA 70 (latest revision) and local codes and ordinances. A copy of this standard may be obtained from:

National Fire Protection Association 1 Batterymarch Park

Quincy, Massachusetts 02269-9101

•The correct voltage, frequency and amperage must be supplied to the appliance from a separate, grounded, circuit that is protected by a properly sized circuit breaker or time delay fuse. If a time-delay fuse is utilized, fuse both sides of the line (L1 and L2).

Electrical Specifications

Circuit Required	Total Connected Load
240 Vac, 60 Hz., 4-wire*, 30 Amp.	5.7 kW (23.8 Amp.)

* Two 120 Vac hot (L1 and L2), one neutral (N1) and one ground.

The above electrical specifications are for reference only. See the range data label for exact specifications. See inside cover for location.

•The wiring needs to be long enough to allow the range to be pulled out for service, while remaining connected.

•The wiring connected to the range must:

◊Meet NEMA standards and have a minimum rating of 250 Volts @ 30 Amp.

◊Include a strain relief.

◊Be terminated by tinned leads, closed loop terminals or open ended spade lugs with upturned ends.

Electrical Requirements

(Models numbers ending with -C)

•Model numbers that end in -C are freestanding ranges that come with a factory installed 4-wire appliance cord and NEMA 14-50P plug. This wiring configuration is required for freestanding ranges installed in Canada, although they may be used elsewhere, if local codes permit. The plug is designed to plug directly into a NEMA 14-50R electrical receptacle installed by a licensed electrician according to the specifications below. Do not modify the factory wiring on models with -C at the end of the model number.

•It is the owner’s responsibility to ensure that the required 4-wire electrical outlet compatible with the power cord is installed by a licensed electrician as specified below prior to range installation. The electrical outlet installation, including minimum supply wire size and grounding, must be in accordance with all governing codes and ordinances.

•The correct voltage, frequency and amperage must be supplied to the appliance from a separate, grounded, circuit that is protected by a properly sized circuit breaker or time delay fuse. If a fuse is utilized, fuse both sides of the line (L1 and L2). Refer to the ratings on the range rating label.

Electrical Specifications

Circuit Required	Total Connected Load
240 Vac, 60 Hz., 4-wire*, 30 Amp.	5.7 kW (23.8 Amp.)

*The ratings above are for reference only - refer to the product data label for exact specifications.

The ratings above are for reference only - refer to the range rating label (see inside cover).

◊ Connect to a junction box or receptacle installed by a
licensed electrician.	NEMA 14-50P Plug	NEMA 10-50P Plug
The appliance may be connected one of the following ways:
• Using conduit:
◊ A 4-wire conduit connected to a 4-wire junction box, or
◊ A 3-wire conduit (where local code permits) connected to
a 3-wire junction box.
Suggested conduit wiring color code: black, white, red and
green.
• Using an appliance cord:
◊ A 4-wire appliance cord equipped with a NEMA 14-50P
plug connected to a NEMA 14-50R receptacle, or	NEMA 14-50R Receptacle	NEMA 10-50R Receptacle
◊ A 3-wire appliance cord (where local code permits)

equipped with a NEMA 10-50P plug connected to a NEMA 10-50R receptacle.

Appliance cord plug must be UL listed type SRD or SRDT.

3