Planning the Installation
Gas Supply Requirements
•Check your local building codes for the proper method of installation. In the absence of local codes, this appliance should be installed in accordance with the National Fuel Gas Code ANSI Z223.1.
•Be certain that the appliance being installed is correct for the gas service provided (natural gas or LP gas). Also, if operating the range at an altitude above 4000 ft. (1219 m) make sure it is equipped for high altitude operation. Refer to the product data label and the table on the inside cover to determine the correct model.
•See the table for gas supply pressure requirements.
•The regulator inlet accommodates a 3/4” gas line. The range ships with a 1/2” to 3/4” adapter connected to the regulator.
| Gas | Manifold | Min. Gas Supply | Max. Input |
| Type | Pressure* (WC) | Pressure (WC) | Pressure |
Natural | 5 | 6 | 1/2 psi |
LP | 10 | 11 | 1/2 psi |
The ratings above are for reference only - refer to the product data label (see inside cover for location).
Electrical and Gas Supply Connections
Gas 
inlet
B
D
Range electrical access, cover removed
A B C D
4 3/4” | 22 1/8” | 8 3/4” | 13 3/4” |
(12.1 cm) | (56.2 cm) | (22.2 cm) | (34.9 cm) |
*When using an appliance cord that is not factory installed, the hole size must be increased to 1 1/8” (2.9 cm) by removing the conduit bracket inside the range electrical access box (see page 14).
A | 7/8” (2.2 cm) dia. electrical |
C | connection hole in bottom* |
4