DCS MO-24SS manual Unpacking and Installation Instructions, Unpacking and Examining Your Oven

Unpacking and Installation Instructions

Unpacking and Examining Your Oven

Remove: all packing materials from inside the oven cavity; however, DO NOT REMOVE THE WAVEGUIDE COVER, which is located on the right cavity wall. Read enclosures and SAVE

the Operation Manual.

Check the oven for any

damage, such as mis-

aligned or bent door,

damaged door seals

and sealing surfaces,

broken or loose door

hinges and latches and

dents inside the cavity or

on the door. If there is

any damage, do not

operate the oven and contact your dealer or DCS

AUTHORIZED SERVICER.

Choosing a Location for Your Oven on the counter

You will use the oven frequently so plan its location for ease of use. It’s wise, if possible, to have counter space on at least one side of the oven. Allow at least 2 inches on the sides, top and at the rear of the oven for air circulation.

OVER OVEN INSTALLATION

	￿TOP OF
	MICROWAVE
	SHELF
MICROWAVE	1"
CUTOUT	(25MM)
	WALL
	OVEN CUTOUT

401/4"

(1022MM)

OVER WARMING OVEN INSTALLATION

Choosing a Location for Your Oven if built-in

Your oven can be built into a cabinet or wall by itself or above any DCS wall oven listed below using DCS’s Built-in Kits, either the MOSTK27 or the MOSTK30. The MOSTK27 is for a 27" wall oven, while the MOSTK30 accommodates installation above 30" wall ovens.

TRIM KIT FRAME

ASSEMBLE

MICROWAVE

CUTOUT

RECOMMENDED HEIGHT 36"

(914MM)

OVEN FRONT

2"

(51MM)

WARMING

OVEN CUTOUT

The applicable wall ovens and warming ovens are as follows:

OVENS - WO 127, WO 130, WOS127, WOS130

WARMING OVENS - WD 27, WD 30, WDS27, WDS30,

WDSI

Do not built-in above any other gas or electric wall oven.

See Built-in Kit Installation Instructions for proper loca- tion when building in above the specified wall ovens. Carefully follow both the wall oven installation instruc- tions and Built-in Kit instructions.

The opening in the wall or cabinet must be within the following dimensions:

A	HEIGHT	:	17" + 1/16", -0
B	WIDTH	:	24 3/4" + 1/16", -0
C	DEPTH	:	minimum 20"

4