Dell 1100, B110 owner manual Removing a PCI Card, Not fully seated card Fully seated card Bracket

not fully seated card
fully seated card	bracket
	within slot

bracket caught outside of slot

4Secure the card bracket with the screw you removed in step 2.

5Connect any cables that should be attached to the card.

See the documentation for the card for information about the card’s cable connections.

NOTICE: Do not route card cables over or behind the cards. Cables routed over the cards can cause damage to the equipment.

6If you installed a sound card:

a Enter system setup (see page 82), select Audio Controller, and then change the setting to Off.

b Connect external audio devices to the sound card’s connectors. Do not connect external audio devices to the microphone, speaker/headphone, or line-in connectors on the back panel.

7If you installed an add-in network adapter and want to disable the integrated network adapter:

a Enter system setup (see page 82), select Network Controller, and then change the setting to Off.

b Connect the network cable to the add-in network adapter’s connectors. Do not connect the network cable to the integrated connector on the back panel.

8Install any drivers required for the card as described in the card documentation.

Removing a PCI Card

1Follow the procedures in "Before You Begin" on page 47.

2If necessary, disconnect any cables connected to the card.

60

Removing and Installing Parts