*1 | Enter 5 in Sleep to put the printer in the Sleep mode five minutes after it finishes a |
| job. This uses less energy, but requires more |
| your printer shares an electrical circuit with room lighting and you notice lights |
| flickering. |
| Select a high value if your printer is in constant use. In most circumstances, this |
| keeps the printer ready to operate with minimum |
| between 5 and 30 minutes for the Sleep mode if you want a balance between energy |
| consumption and a shorter |
| The printer automatically returns to the standby mode from the Sleep mode when it |
| receives data from the computer. You can also return the printer to the standby mode |
| by pressing any button on the operator panel. |
*2 | The default for mm/inch and Default Print Paper Size vary depending on country- |
| specific factory default. |
|
|
Paper Density
Purpose:
To specify the paper density.
Values:
Plain | Normal* | Specifies the paper density of plain paper. |
|
|
|
| Light |
|
|
|
|
Label | Normal* | Specifies the paper density of labels. |
|
|
|
| Light |
|
|
| |
Apply New Settings | After you complete the settings, press the Apply New | |
|
| Settings button to apply the changes. |
Restart printer to apply new settings
Press the Restart printer to apply new settings button to apply the changes.
Adjust BTR
Purpose:
To specify the optimum voltage settings for printing for the transfer roller (BTR). To lower the voltage, set negative values. To increase, set positive values.
The default settings may not give the best output on all paper types. If you see mottles on the print output, try to increase the voltage. If you see white spots on the print output, try to decrease the voltage.
Understanding the Tool Box Menus
