Configuring the PowerConnect 3324/3348 Switch 65
**************************************************
***************** SYSTEM RESET *****************
**************************************************
.
.
.
.
Remote Management Access
To allow remote device management (Telnet, Web etc.) perform the following:
1Enter the command enable at the console to enter the Privileged EXEC screen mode
as follows:
console>enable
console#
2Connect the management station (PC) to the device via one of the Ethernet ports (or
via a network connected to the device) using a CAT5 Cable, to port e1 in this example.
Ensure (on the ASCII terminal) that the interface status changed to “up” and that the
STP status is forwarding (after 30 seconds):
console>enable
Console#
01-Jan-2000 01:43:03 %LINK-I-Up: Vlan 1
01-Jan-2000 01:43:03 %LINK-I-Up: 1/e1
01-Jan-2000 01:43:34 %STP-I-PORTSTATUS: Port 1/e1: STP status
Forwarding
3Enter the command configure at the console to enter the Configuration screen mode
as follows:
console> enable
console# configure
console(config)#