Dell 3324, 3348 Rebooting the Device

76 Configuring the PowerConnect 3324/3348 Switch

www.dell.com | support.dell.com

4Select Unit 2 using the Stack ID button within 15 seconds.

5Repeat steps 3 and 4 for all stacking members.

NOTE: Stack the units according to their Unit ID. For example, the Master Unit is stacked

first, with Unit 2 directly below the Master Unit.

This section contains instructions for adding stacking members. To expand a stack:

NOTE: The Stack Unit ID must be selected within 15 seconds.

1Ensure that the stack is operating correctly.

2Connect the lower Stacking connector to the additional stacking Member unit.

3Plug in new stacking unit. The device begins to boot.

4Select the unit number using the Stack ID button within 15 seconds.

5For each new member, open the existing ring and connect the new member’s Stacking

cable.

For information on replacing stacking members and reassigning Unit IDs, see "Replacing

Stack Members".

Rebooting the Device

NOTE: Before rebooting the device, save the device configuration. After the device is reset, all

unsaved configuration changes are lost.

1Enter the CLI mode. The following prompt displays:

Console > enable

2Enter Reload. The following message displays:

>reload

This command will restart the whole system and disconnect your

current session. Do you want to continue?

3Enter Y. The device reboots.