Replacing the Palm Rest | 29
10 Replacing the Palm Rest
WARNING:
Before working inside your computer, read the safety information that
shipped with your computer and follow the steps in "Before You Begin" on page 9.
For additional safety best practices information, see the Regulatory Compliance
Homepage at dell.com/regulatory_compliance.
Procedure
1Align the palm rest with the computer base and gently snap the palm rest
into place.
2Slide the hot-key board cable, power-button board cable, and touchpad cable into
the system-board connectors and press down on the connector latches to secure
the cables.
3Replace the screws that secure the palm rest to the computer base.
4Close the display and turn the computer over.
5Replace the screws that secure the palm rest to the computer base.
Postrequisites
1Replace the keyboard. See "Replacing the Keyboard" on page 25.
2Replace the base cover. See "Replacing the Base Cover" on page 19.
3Follow the instructions in "After Working Inside Your Computer" on page 11.
book.book Page 29 Tuesday, April 17, 2012 11:08 AM