Table 4. Status Summary Screens (continued)
Status Summary Screen | Description | ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Normal Mode |
|
|
|
|
|
|
| The UPS is operating in Normal mode from utility power. The UPS monitors and |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| charges the batteries as needed and provides filtered power protection to your |
|
|
|
|
|
|
| equipment. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Standby Mode
When the UPS is turned off and remains plugged into a power outlet, the UPS is in Standby mode and utility power supplies the connected equipment. The UPS is not supporting the load, but is ready to assume the load on command.
The notice and alarm screens are visible only when notices or alarms are active. There is a separate screen for each active notice or alarm. If there are no active notices or alarms, a “No Active Alarms” message appears in a single screen between the UPS status summary and the battery status screen. If there are multiple notices or alarms, scroll through each notice or alarm screen to reach the first battery status screen.
NOTE: Events are not shown in status summary screens. They appear only in the Event Log.
Table 5 describes the available battery status screens. Only one battery status is available at a time.
Table 5. Battery Status Screens
Battery Status Screen | Description |
|
|
Battery charging | Batteries are charged in constant current mode. |
|
|
Battery floating | Batteries are charged in constant voltage mode. |
|
|
Battery resting | Batteries are connected but are not being charged or discharged. |
| (This is part of the normal charging cycle.) |
|
|
Battery discharging | Batteries are discharging. |
|
|
Battery disconnected | Batteries are unavailable because they are disconnected. |
|
|
Charger disabled | The battery charger is off. You can enable the Charger setting from the Settings |
| menu (see page 38). |
|
|
Operation 33
