Dell K788N, K789N Settings continued, Description, Available Settings, Default Setting, Operation

Table 7. Settings (continued)

Description	Available Settings	Default Setting
Set Date and Time	Set Month, Day, Year, Hours, Minutes, and Seconds
	Date:mm/dd/yyyy	01/01/2009
	Time: hh:mm:ss	12:00:00
	NOTE: The date format is dependent on the
	language selection.

NOTE: Time is a 24-hour clock.

Control Commands from Serial Port

[Enabled] [Disabled] Enabled

If Enabled, control commands are accepted through the serial port, USB ports, or option card.

If Disabled, configuration and load control commands are restricted to LCD only.

Output Voltage	[100V] [110V] [120V] [Auto-sensing]	Auto-sensing
	[200V] [208V]
	[220V] [230V] [240V]
Output Frequency	[50Hz] [60Hz] [Auto-sensing]	Auto-sensing
Overload Alarm Level	[10%] [20%] [30%]...[100%]	100%
	If 100%, the UPS issues an Output Overload alarm
	at load > 100%.
	NOTE: Output Overload Level 1 by default is set to
	100% and is configurable from 10% to 100% in 10%
	increments through the LCD setting menu. This
	allows customers to be alerted before the UPS has
	reached its rated capacity limits.
Automatic Start Delay	[Off] [0s] [1s] [2s]...[32767s]	0s
	See “Configuring Load Segments” on page 41.
Automatic on Battery Shutdown	[Off] [0s] [1s] [2s]...[32767s]	Off
	See “Configuring Load Segments” on page 41.
Start on Battery	[Enabled] [Disabled]	Enabled
	NOTE: Battery start is disabled from the factory and
	remains disabled until the UPS has been powered
	from utility and enters Standby mode. After the
	UPS has been started once from utility, the Start on
	Battery feature is automatically enabled. After this is
	set by the user, it remains set.

Operation 37