Network Transient Protector
The network transient protector, shown in Figure 23, is located on the rear panel and has jacks labeled IN and OUT. This feature accommodates a single RJ‐45 (10BaseT) network connector.
NOTE: DO NOT connect any telephone or fax/modem equipment
1Connect the input connector of the equipment you are protecting to the jack labeled IN.
2Connect the network cable to the jack labeled OUT.
OUT
OUTIN
IN
1920/1500W
Figure 23. Network Transient Protector
Dell UPS Management Software
Each Dell Tower UPS ships with Dell UPS Management Software.
Dell UPS Management Software provides
For details on disabling control commands from the software, see the user setting for Control Commands from Serial Port setting on page 37.
Additional UPS Features | 49 |