Dell R820 owner manual Processors, Installing The Network Daughter Card

Figure 43. Removing and Installing the Network Daughter Card
1.	captive screw sockets (2)	5.	network daughter card
2.	connector on the system board	6.	slot for RJ-45 connectors in the back panel

3.captive screws (2)

4.touch point

Installing The Network Daughter Card

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

1.Angle the card so that the RJ-45 connectors fit through the back-panel opening.

2.Align the captive screws at back-end of the card with the screw holes on the system board.

3.Press the touch point on the card to ensure that connector on the card is in contact with the connector on the system board.

4.Using a #2 Phillips screwdriver, tighten the two captive screws to secure the network daughter card to the system board.

5.If you are not installing a 10 GbE network daughter card, install the PCH shroud:

a)Align the screws on the PCH shroud with the screw holes on the system board.

b)Replace the screws that secure the PCH shroud to the system board.

6.Install the expansion card riser 1.

7.Close the system.

8.Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.

Processors

Use the following procedure when:

77