Verwendung dieses Produkts in der Schweiz
Für dieses Produkt muss ein schweizerischer Billing Tone Filte r zur Zählzeichenübertragung für jede Leitung installi ert
werden, über die in der Schweiz Zeitsteuertakte übertragen werden. Die Verwendung des Filters ist obligatorisch, da
in allen analogen Telefonleitungen in der Schweiz Zeitsteuertakte vor handen sind.
Uso del prodotto in Svizzera
Questo prodotto richiede un filtro toni Billing svizzero, a installare su tutte le linee che ricevono i mpulsi remoti in
Svizzera. È necessario utilizzare il filtro poiché gli impulsi remoti sono presenti su t utte le linee analogiche in Svizzera.
Notice to Users in the European Union
Products bearing the CE mark are in conformity wit h the protection requirements of E C Council directives 2004/108/E C,
2006/95/EC, and 1999/5/EC on the approximation and harm onization of the laws of the Member States relating to
electromagnetic compatibility, safety of electrical equipment designed for use within certain voltage limits and on radio
equipment and telecommunications terminal equipment.
Compliance is indicated by the CE marking.
The manufacturer of this product is: Lexmark International, Inc., 740 We st New Circle Road, Lexington, KY, 40550 USA.
The authorized representative is: Lexmark International Technology Hungária Kft., 8 Lec hner Ödön fasor, Millennium
Tower III, 1095 Budapest HUNGARY, A declaration of conformity to the requireme nts of the Directives is available upon
request from the Authorized Representative.
Refer to the table at the end of the Notices section for further compliance information.
Regulatory notices for wireless products
This section contains the following regulatory information pertaining to wireless products that contain transmitters,
for example, but not limited to, wireless network cards or proxi mity card readers.
Exposure to radio frequency radiation
The radiated output power of this device i s far below the radio f requency exposure limits o f the FCC and other regulat ory
agencies. A minimum separation of 20 cm (8 inches) must be maintai ned between the antenna and any persons for
this device to satisfy the RF exposure requirements of the FCC and other regulatory agencies.
Industry Canada (Canada)
This device complies with Industry Canada specification RSS-210. Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must ac cept any interference, including interference t hat
may cause undesired operation of the device.
Notices 167