Dell W4201C, W3201C Product Information Guide, The power supply cord or the plug has been damaged

w w w . d e l l . c o m s u p p o r t . d e l l . c o m

•Damage Requiring Service — The appliance should be serviced by qualified service personnel when:

•The power supply cord or the plug has been damaged

•Objects have fallen, or liquid has been spilled into the appliance

•The appliance has been exposed to rain

•The appliance does not appear to operate normally or exhibits a marked change in performance

•The appliance has been dropped, or the enclosure damaged.

•Tilt/Stability — All televisions must comply with recommended international global safety standards for tilt and stability properties of its cabinets design.

•Do not compromise these design standards by applying excessive pull force to the front, or top of the cabine which could ultimately overturn the product.

•Do not place electronic equipment/toys on the top of the set. As such items could unsuspectingly fall from the top of the set and cause product damage and/or personal injury.

•Wall or Ceiling Mounting — The TV display should be mounted to a wall or ceiling only as recommended by the manufacturer.

•Power Lines -— An outdoor antenna should be located away from power lines.

•Outdoor Antenna Grounding — If an outside antenna is connected to the receiver, be sure the antenna system is grounded so as to provide some protection against voltage surges and built up static charges. Section 810 of the National Electric Code. ANSI/NFPA No.70-1984, provides information with respect to proper grounding of the mats and supporting structure grounding of the lead-in wire to and antenna-discharge unit, size of grounding connectors, location of antenna-discharge unit, connection to grounding electrodes and requirements for the grounding electrode.

Example of Antenna Grounding as per National Electrical Code (NEC)

Ground Clamp

Antenna Lead in Wire

Antenna Discharge Unit (NEC section 810-20)

Grounding Conductors (NEC section 810-21)

Electric Service Equipment

Ground Clamp

Power service grounding electrode system (NEC Art 250 , Part H )

•See the limited warranty section for service of your TV display. Servicing is required when the TV display has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into TV display the TV display has been exposed to rain or moisture, does not operate normally, or has been dropped.

NOTE: This note is for cabel TV display installers, Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system fo the building, as close to the point of cable entry as practical.

18

Product Information Guide