Removing and Installing Parts 95
7
Connect a power cable to the drive.
8
Connect the hard-drive cable to the drive and to the system board (see page 75).
9
Close the computer cover (see page 114).
NOTICE: To connect a network cable, first plug the cable into the network device and then plug it into
the computer.
10
Connect your computer and devices to their electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software
required for drive operation.
Floppy Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions
located in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet
before opening the cover.
Follow the procedure in "Before You Begin" on page 67.
NOTE: If you are adding a floppy drive, see "Installing a Floppy Drive" on page 96.
rail tabs (2)
second hard drive
in upper bay
hard drive bay
first hard drive in
lower bay