Dell WorkStation 410 manual RQQHFWWKH6&6,GHYLFHVWRDSRZHUVRXUFH, $/57&RYHUZDVSUHYLRXVO\UHPRYHG

￿￿&RQQHFW￿WKH￿6&6,￿GHYLFH￿V￿￿WR￿D￿SRZHU￿VRXUFH￿

‡If you are installing an internal SCSI device, connect a DC power cable to the power input connector on the SCSI device.

‡If you are installing an external SCSI device, connect the socket end of the power cable into the AC power receptacle on the back of the SCSI device. Connect the other end of the power cable into a standard electrical wall outlet.

Check all other cable connections. Fold all internal cables out of the way to pro- vide airflow for the fan or cooling vents.

￿￿,I￿\RX￿LQVWDOOHG￿DQ￿H[WHUQDOO\￿DFFHVVLEOH￿GHYLFH￿￿UHPRYH￿WKH￿IURQW￿SDQHO￿ LQVHUW￿IRU￿WKH￿GULYH￿ED\￿￿

For instructions, see “Removing and Replacing Front-Panel Inserts” found earlier in this chapter.

￿￿5HSODFH￿WKH￿FRPSXWHU￿FRYHU￿￿7KHQ￿UHFRQQHFW￿\RXU￿FRPSXWHU￿DQG￿SHULSK￿ HUDOV￿WR￿WKHLU￿SRZHU￿VRXUFHV￿￿DQG￿WXUQ￿WKHP￿RQ￿

NOTE: After you remove and replace the cover, the chassis intrusion detector will cause the following message to be displayed at the next system start-up:

$/(57￿￿&RYHU￿ZDV￿SUHYLRXVO\￿UHPRYHG￿

￿￿7R￿UHVHW￿WKH￿FKDVVLV￿LQWUXVLRQ￿GHWHFWRU￿￿HQWHU￿WKH￿6\VWHP￿6HWXS￿SURJUDP￿ DQG￿UHVHW￿&KDVVLV￿,QWUXVLRQ￿WR￿1RW￿'HWHFWHG￿

See Chapter 3, “Using the System Setup Program,” for instructions.

NOTE: If a setup password has been assigned by someone else, contact your network administrator for information on resetting the chassis intrusion detector.

￿￿,I￿QHFHVVDU\￿￿XSGDWH￿WKH￿GULYH￿V\VWHP￿FRQILJXUDWLRQ￿LQIRUPDWLRQ￿LQ￿WKH￿ 6\VWHP￿6HWXS￿SURJUDP￿

For any SCSI devices, the respective category under Drives: Primary or Drives: Secondary should be set to None. For instructions, see Chapter 3, “Using the System Setup Program.”

￿￿￿,I￿\RX￿LQVWDOOHG￿D￿6&6,￿KDUG￿GLVN￿GULYH￿￿SDUWLWLRQ￿DQG￿IRUPDW￿WKH￿GULYH￿￿ 7KHQ￿LQVWDOO￿WKH￿RSHUDWLQJ￿V\VWHP￿￿

For instructions, see the next subsection, “Partitioning and Formatting SCSI Hard-Disk Drives,” and your operating system documentation.

￿￿￿7HVW￿WKH￿6&6,￿GHYLFHV￿

Test a SCSI hard-disk drive by running the SCSI diagnostics. See your Diagnostics and Troubleshooting Guide for information on running the Dell Diagnostics and troubleshooting any problems that may occur.

To test a SCSI tape drive, refer to the documentation for the tape drive software to perform a tape drive backup and verification test.

Installing Drives 10-19