Dell WorkStation 410 manual LJXUH6&&DUWULGJH+HDW6LQN$VVHPEO\5HPRYDO, Frqqhfwru

￿

thumbscrews (2)

SEC cartridge

heat sink

SEC cartridge release latches (2)

guide bracket assembly

)LJXUH￿￿￿￿￿￿￿6(&￿&DUWULGJH￿+HDW￿6LQN￿$VVHPEO\￿5HPRYDO￿￿￿

￿￿,QVHUW￿WKH￿QHZ￿6(&￿FDUWULGJH￿KHDW￿VLQN￿DVVHPEO\￿LQWR￿WKH￿V\VWHP￿ERDUG￿

FRQQHFWRU￿

Press the SEC cartridge firmly into its connector until it is fully seated and the latches snap into place. You must use up to 25 lb of force to fully seat the SEC cartridge in its connector. Install or replace the two large thumbscrews that secure the heat sink to the system board.

￿￿,I￿QHFHVVDU\￿￿FKDQJH￿WKH￿SURFHVVRU￿VSHHG￿MXPSHU￿VHWWLQJ￿￿VHH￿ )LJXUH %￿￿￿WR￿ORFDWH￿V\VWHP￿ERDUG￿MXPSHUV￿￿

The processor speed jumper should be set for the installed microprocessor’s rated internal speed. For example, for a 350-megahertz (MHz) Intel Pentium II processor, a jumper plug should be installed on the pins labeled “350MHZ.” (See Appendix B, “Hardware Configuration Features,” for more information on the jumpers.)

9-12'HOO￿3UHFLVLRQ￿￿￿￿￿'HVNWRS￿6\VWHPV￿8VHU©V￿*XLGH