Dell WorkStation 410 manual 7DEOH&&RQILJXUDWLRQ0DQDJHU0HVVDJHV

&RQILJXUDWLRQ￿0DQDJHU￿0HVVDJHV￿

The Configuration Manager for the ICU identifies problems following the system boot routine and generates messages if necessary. These messages alert you to any unsuccessful attempts to configure Plug and Play or Peripheral Component Inter- connect (PCI) expansion cards, as well as any problems that interfere with the operation of the Configuration Manager. If you receive a message from the Configura- tion Manager, see Table C-2 for suggestions on resolving any problems indicated by the message.

7DEOH￿&￿￿￿￿￿&RQILJXUDWLRQ￿0DQDJHU￿0HVVDJHV ￿￿￿￿

0HVVDJH 3UREDEOH￿&DXVH &RUUHFWLYH￿$FWLRQ

)RXQG￿3OXJ￿DQG￿3OD\￿ ,6$￿FDUG￿￿3OXJ￿DQG￿3OD\￿ ,6$￿&DUG￿1DPH￿

This message appears at	Status message; no action is required.
system start-up for each
Plug and Play ISA expan-
sion card recognized by
the Configuration
Manager.

127,&(￿￿%RRW￿'HYLFH￿	A boot device was found	Status message; no action is required. The
1RW￿$FWLYH￿￿&61 &DUG￿	to be inactive.	Configuration Manager automatically config-
6HOHFW￿1XPEHU￿		ures and activates the device.
2QH￿RU￿PRUH￿DFWLYH￿	You modified the	Reboot the system to reconfigure the card(s).
GHYLFHV￿KDYH￿EHHQ￿	resource values of one or
UHFRQILJXUHG￿￿￿￿V\V￿	more PCI or Plug and Play
WHP￿UHTXLUHV￿UHERRW￿￿	ISA expansion cards.
3UHVV￿DQ\￿NH\￿WR￿
UHERRW￿V\VWHP￿

7KH￿3OXJ￿DQG￿3OD\￿,6$￿	The Configuration Man-
FDUG￿KDV￿EHHQ￿VXFFHVV￿	ager has successfully
IXOO\￿FRQILJXUHG￿	configured the given
	number of cards.
&DUG￿&RXQW￿3OXJ￿DQG￿
3OD\￿,6$￿FDUGV￿KDYH￿
EHHQ￿VXFFHVVIXOO\￿
FRQILJXUHG￿

If this message does not match the number of Plug and Play ISA expansion cards installed in your computer, reinstall any Plug and Play expansion cards not listed and reboot the system.

(5525￿￿,QVXIILFLHQW￿&0￿	There is not enough
0HPRU\	memory available to the
	Configuration Manager
	for it to run.

Disable any TSR programs or any unneeded device drivers.

(5525￿￿)DWDO￿%,26￿ HUURU￿,QWHUQDO￿(UURU￿ &RGH￿

A BIOS call failed with an internal error. The most likely cause is an incom- patibility between the BIOS and the Configura- tion Manager.

See the chapter titled “Getting Help” in your Diagnostics and Troubleshooting Guide for instructions on obtaining technical assistance.

NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary.

ISA Configuration Utility Messages C-7