Dell WorkStation 410 manual Qvwdoolqjdq,+Duglvnulyh, 8SGDWH\RXUV\VWHPFRQILJXUDWLRQLQIRUPDWLRQ

￿￿￿5HSODFH￿WKH￿FRPSXWHU￿FRYHU￿￿DQG￿UHFRQQHFW￿\RXU￿FRPSXWHU￿DQG￿SHULSK￿ HUDOV￿WR￿WKHLU￿SRZHU￿VRXUFHV￿DQG￿WXUQ￿WKHP￿RQ￿

NOTE: After you remove and replace the chassis, the chassis intrusion detector will cause the following message to be displayed at the next system start-up:

$/(57￿￿&RYHU￿ZDV￿SUHYLRXVO\￿UHPRYHG￿

￿￿￿7R￿UHVHW￿WKH￿FKDVVLV￿LQWUXVLRQ￿GHWHFWRU￿￿HQWHU￿WKH￿6\VWHP￿6HWXS￿SURJUDP￿ DQG￿UHVHW￿&KDVVLV￿,QWUXVLRQ￿WR￿1RW￿'HWHFWHG￿

See Chapter 3, “Using the System Setup Program,” for instructions.

NOTE: If a setup password has been assigned by someone else, contact your network administrator for information on resetting the chassis intrusion detector.

￿￿￿8SGDWH￿\RXU￿V\VWHP￿FRQILJXUDWLRQ￿LQIRUPDWLRQ￿

For a diskette drive, update the appropriate Diskette Drive category (A or B) on Page 1 of the System Setup screens to reflect the size and capacity of your new diskette drive. (For more information, see Chapter 3, “Using the System Setup Program.”)

For EIDE CD-ROM and tape drives, set the appropriate Drive category (0 or 1) under Drives: Secondary to Auto.

￿￿￿9HULI\￿WKDW￿\RXU￿V\VWHP￿ZRUNV￿FRUUHFWO\￿

See your Diagnostics and Troubleshooting Guide for information on running the Dell Diagnostics and troubleshooting any problems that may occur. Use the fol- lowing guidelines to determine which test to use:

‡If you installed a diskette drive, test it by running all of the subtests in the Diskette Drives Test Group of the Dell Diagnostics.

‡If you installed a CD-ROM drive, see the documentation that came with the drive for instructions on loading device drivers and using the drive. If it is an EIDE CD-ROM drive, test it by running all of the subtests in the IDE CD-ROM Drives Test Group of the Dell Diagnostics.

‡If you installed a tape drive, perform a tape backup and verification test with the drive as instructed in the tape-drive software documentation that came with the tape drive.

NOTE: The tape drives sold by Dell come with their own operating software and documentation. After you install a tape drive, refer to the documentation that came with the drive for instructions on installing and using the tape drive software.

,QVWDOOLQJ￿DQ￿(,'(￿+DUG￿'LVN￿'ULYH

This section includes information on installing, partitioning, and formatting EIDE hard- disk drives. For instructions on installing, partitioning, and formatting SCSI hard-disk drives, see “Installing SCSI Devices” found later in this chapter.

Installing Drives 10-9