Setting the Time Code
Selecting the Run Options
E
You can select from record run
You can select the start point for the
MENU | SIGNAL SETUP |
| TIME CODE |
| ||
|
| |||||
( | 29) |
|
|
|
|
|
|
|
|
|
|
|
|
1. Open the menu and select [SIGNAL SETUP]. Select the [TIME CODE] submenu and then
2. Select [SET].
The hours display flashes.
3. Set the time code’s starting value.
Turn the SELECT dial to set the value for the hours and press the SET button. The next field of the display starts flashing. Set the value for the minutes, seconds and frames in the same way.
4. Close the menu.
About the time code display
- | The time code will be displayed with an | R | next to it. | ||||
- | The time code will be displayed in blue with a |
|
| next to it. | |||
P | |||||||
- | The time code will be displayed in blue with an |
| next to it. | ||||
F |
- External Time Code: | The time code will be displayed in blue with an | E | next to it. |
- Time Code Hold: | The time code will be displayed in blue with an |
| next to it. |
H | |||
- Playback: | No time code display. |
When setting the
To reset the time code to [00:00:00:00], select [RESET] in step 2.
When recording over existing scenes: When a time code discontinuity occurred near the recording start point, the time code at the point where the recording starts may be discontinuous.
As long as the
Recording
55