Dell XPS 14Z owner manual Entering the Service Tag in the Bios

10Adhere the pull-tab on the keyboard cable over the keyboard cable connector on the system board.

11Replace the heat sink and fan (see "Replacing the Heat Sink and Fan" on page 42).

12Replace the optical drive (see "Replacing the Optical Drive" on page 33).

13Replace the coin-cell battery (see "Replacing the Coin-Cell Battery" on page 30).

14Replace the hard drive (see "Replacing the Hard Drive" on page 28).

15Replace the Mini-Card (see "Replacing the Mini-Card" on page 23).

16Replace the battery (see "Replacing the Battery" on page 16).

17Replace the base cover (see "Replacing the Base Cover" on page 12).

18Replace any blank or card you removed from the Media Card Reader.

CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in damage to the computer.

19Turn on the computer.

NOTE: After you have replaced the system board, enter the computer Service Tag in the BIOS of the replacement system board.

20Enter the Service Tag (see "Entering the Service Tag in the BIOS" on page 49).

Entering the Service Tag in the BIOS

1Ensure that the AC adapter is plugged in and that the main battery is installed properly.

2Turn on the computer.

3Press <F2> during POST to enter the System Setup program.

4Navigate to the Security tab and enter the Service Tag in the Set Service Tag field.

System Board

49