
Security
Supervisor Password | Displays the status of supervisor password |
| (Not Installed by default) |
User Password | Displays the status of user password |
| (Not Installed by default) |
Set Supervisor Password | Allows to set, change, or delete the |
| supervisor password |
| NOTE: Deleting the supervisor password |
| will delete the user password. Hence, the |
| supervisor password must be set before |
| setting the user password. |
HDD Protection | Enabled or Disabled (Disabled by |
| default) |
Set User Password | Allows to set, change, or delete the user |
| password |
Password Check | Setup or Always |
| Specifies when the user must enter |
| Supervisor Password; when entering |
| System Setup or Always (Setup by |
| default) |
|
|
Exit |
|
|
|
Exit options | Provides options to Save Changes and |
| Reset, Discard Changes and Reset, and |
| Load Defaults |
|
|
Boot Sequence
This feature allows you to change the boot sequence for devices.
Boot Options
•Diskette Drive — The computer attempts to boot from the floppy disk drive. If no operating system is on the drive, the computer generates an error message.
•Hard Drive — The computer attempts to boot from the primary hard- drive. If no operating system is on the drive, the computer generates an error message.
System Setup Utility