DeLonghi DE609MP Inside Of Oven, Grill Heating Element, Grease Filter, Replacing The Oven Light

Models: DE609MP

1 48
Download 48 pages 27.47 Kb
Page 42
Image 42
INSIDE OF OVEN

INSIDE OF OVEN

The oven has a specific “PYROLYSIS FUNCTION” which can clean the cavity by pulveri- sing the residual cooking greases by high temperature.

Do not wait for the oven to be very greasy before performing this cleaning.

It should not be performed after every cooking, either, but only when the level of dirt justifies it (on average 1 – 2 times a month depending on oven use).

To use this function see the specific chapters.

Take the baking/grill tray, shelves and grease filter (if fitted) out of the oven. They can be washed in the sink.

Manual cleaning of the oven:

■■ The oven should always be cleaned after use when it has cooled down. Let the oven cool down and pay special attention no to touch the hot heating elements inside the oven cavity.

■■ The cavity should be cleaned using a mild detergent solution and warm water.

■■ Suitable proprietary chemical cleaners may be used after first consulting with the ma- nufacturers recommendations and testing a small sample of the oven cavity.

■■ Abrasive cleaning agents or scouring pads/cloths should not be used on the cavity surface.

■■ NOTE: The manufacturers of this appliance will accept no responsibility for damage caused by chemical or abrasive cleaning.

GRILL HEATING ELEMENTREPLACING THE OVEN LIGHT Do not store flammable material in the oven.

GRILL HEATING ELEMENT

■■ The heating element is self-cleaning and does not require maintenance.

GREASE FILTER

■■ Clean the filter after any cooking! The grease filter can be removed for cleaning and should be washed regularly in hot soapy water (fig. 10 at page 14).

■■ Always dry the filter properly before fitting it back into the oven.

REPLACING THE OVEN LIGHT

WARNING: Ensure the appliance is switched off before replacing the lamp to avoid the possibility of electric shock.

■■ Let the oven cavity and the heating elements to cool down.

■■ Switch off the electrical supply.

■■ Remove the protective cover “A” (fig. 19).

■■ Unscrew and replace the bulb “B” with a new one suitable for high temperatu- res (300 °C) having the following spe- cifications: 220-240V or 230-240V, 50 Hz, E14 and same power (check watt power as stamped in the bulb itself) of the replaced bulb.

■■ Refit the protective cover.

NOTE: Oven bulb replacement is not cove- red by your guarantee.

Figure 19

B

A

38

Page 42
Image 42
DeLonghi DE609MP manual Inside Of Oven, Grill Heating Element, Grease Filter, Replacing The Oven Light