STAINLESS STEEL AND ALUMINIUM PARTS AND SILK- SCREEN PRINTED SURFACES
■Clean using an appropriate product. Always dry thoroughly.
IMPORTANT: these parts must be cleaned very carefully to avoid scratching and abrasion. You are advised to use a soft cloth and neutral soap.
WARNING
When correctly installed, your product meets all safety requirements laid down for this type of product category.
However special care should be taken around the rear or the underneath of the appliance as these areas are not designed or intended to be touched and may contain sharp or rough edges, that may cause injury.
REMOVING AND REASSEMBLING THE SLIDING SHELVES AND THE CATALYTIC PANELS
■The sliding shelves and the catalytic panels can be removed easily by unscrewing the fixing screws and detaching them from the oven walls (fig. 6.1).
Removing the sliding shelves improves access to the oven ceiling for cleaning (after the grill heating element has been lowered - fig. 6.2).
■Reassemble the sliding shelves on the oven walls using the 2 screws and interposing the catalytic panels A and B with the arrow up (fig. 6.1). The catalytic panel A with the hole for the side oven lamp must be positioned on the left oven wall. DO NOT INTERPOSE THE CATALYTIC PANEL B ON THE LEFT OVEN WALL.
A | B |
Fig. 6.1 |
|
Fig. 6.2 |
37 |