Pushstick, Constructing a Push Stick | Delta 33-890, 33-892, 33-891

CONSTRUCTING A PUSH STICK

When ripping work less than 4 inches wide, a push stick should be used to complete the feed and could easily be made from scrap material by following the pattern shown.

PUSHSTICK	MAKEFROM1/2"OR3/4" WOODORTHICKNESS LESSTHANWIDTHOF MAT’L.TOBECUT		NOTCHTOHELP PREVENTHAND FROMSLIPPING
	CUTOFFHERETO PUSH1/4"WOOD	CUTOFFHERETO PUSH1/2"WOOD	1/2"SQUARES

25

Image 25

Delta 33-890, 33-892, 33-891 instruction manual Pushstick, Constructing a Push Stick

Contents

Radial Arm Saw General Safety Rules Additional Safety Rules for Radial ARM Saws Motor Specifications Power ConnectionsGrounding Instructions Extension Cords Unpacking and Cleaning Operating Controls Assembling Steel Legs to Base AssemblyAssembling Overarm Elevating Handle Assembling Cuttinghead To Track ARM Illustrates the starter box assembled to the base Assembling Starter BOX to Base Adjusting Table Brackets Parallel to Track ARM Page Assembling Table Clamps Table Clamp Rods Assembling Table Boards Assembling SAW Blade and Blade Guard AssemblyPage ON/OFF Switch Operating Controls and AdjustmentsAdjusting Overarm Column Assembly Adjusting Yoke Clamp Handle Adjusting Track Rods Adjusting Cuttinghead Ball Bearings Against Track Rods Adjusting Blade Square with Table TOP Adjusting Track ARM Clamp Handle Adjusting SAW Travel Square with Fence CROSS-CUT Stop Removing Heeling in SAW CUT Adjusting Track ARM Stop Adjusting Blade Guard and ANTI-KICKBACK ROD CROSS-CUTTING Assembling Accessory 33-967 Moulding Cutterhead Guard Compound Miter Cutting Miter CuttingRipping OUT-RIPPING IN-RIPPING Constructing a Push Stick PushstickPage Accessories PARTS, Service or Warranty Assistance Canadian PORTER-CABLE Delta Service Centers