3.Place wrench (F) Fig. 19, between inner flange (G), and outer flange (H) and tighten arbor nut (E). Make certain wrench (F) is above the table surface. If necessary raise track arm.
4.Loosen cuttinghead clamp knob (J) Fig. 20 and move cuttinghead (C) to the front of track arm (K). Loosen track arm locking lever (L), pull out on track arm index knob (M) and rotate track arm (K) until wrench (F) is over left table bracket (N). Make certain wrench (F) is in the vertical position and tighten knob (J) and lever (L) Fig. 20.
5.Using wrench (D) Fig. 21 as a feeler gage, lower the track arm assembly by turning handle (P) until wrench (F) just touches wrench (D). IMPORTANT: Do not raise or lower track arm any further until table brackets are adjusted.
6.Loosen track arm locking lever (L) Fig. 20, pull out on track arm index knob (M) and rotate track arm (K) until wrench (F) Fig. 22 is directly above rear table bracket (N). Tighten knob (J) and lever (L) Fig. 20. Using wrench (D) Fig. 22 as a feeler gage, check to see if the height of the cuttinghead (C), at the rear of the table bracket (N) is the same height as the front table bracket.
G
E
H
F
Fig. 19
L
M
J
K
C
F
N
Fig. 20
F
D
P
Fig. 21
FC
ND
Fig. 22
11
