Delta 33-892, 33-890, 33-891 instruction manual Additional Safety Rules for Radial ARM Saws

ADDITIONAL SAFETY RULES FOR

RADIAL ARM SAWS

WARNING: FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY

1.IF YOU ARE NOT thoroughly familiar with the operation for Radial Saws, obtain advice from your supervisor, instructor, or other qualified person.

2.MAKE SURE wiring codes and recommended electrical connections are followed and that machine is properly grounded.

3.KEEP saw blade sharp and free of all rust and pitch.

4.KEEP blade and arbor flanges free from dirt and grease.

5.MAKE SURE end plate is securely fastened to track arm before using saw.

6.BE SURE that all clamp handles are properly tightened before operating machine.

7.DO NOT perform any cutting operation freehand, that is without using the fence to support or guide the work.

8.WHEN FINISHED cross-cutting, always return the cutting-head to the rear of the track arm.

9.ALWAYS follow warning on saw guard for instructions on ripping to be absolutely certain of not ripping from the wrong end.

10.KNOW HOW to reduce the risk of kickback. Always use anti-kickback fingers when ripping. The guard should be lowered on the in-feed end and the anti- kickback attachment adjusted accordingly.

11.NEVER feed work into the anti-kickback end of the machine.

12.ALWAYS turn off power and wait until saw blade stops turning before moving workpiece or changing operational settings.

13.SHUT OFF the power and do not leave until the blade has come to a complete stop.

14.DIRECTION OF FEED. On ripping operations, feed work into the blade or cutter against the direction of rotation of the blade or cutter only.

15.ALWAYS use push-stick when ripping narrow work.

16.KEEP hands out of path of saw blade.

17.NEVER reach around or in back of saw blade.

18.USE only 12" saw blades with a 5/8" arbor hole.

19.DO NOT leave cut-off pieces on the table as they may vibrate into the saw blade and be thrown out. After cutting, turn saw off and remove cut-off pieces only after the blade has come to a complete stop.

20.NEVER start saw with the saw blade engaged in the workpiece.

21.MAKE SURE that long or wide workpieces are prop- erly supported

22.NEVER perform a “crossed arm” operation. Keep arms and hands out of path of saw blade.

23.IMPORTANT: When the tool is not in use, the switch should be locked in the “OFF” position to prevent unauthorized use.

24.ADDITIONAL INFORMATION regarding the safe and proper operation of this product is available from the National Safety Council, 1121 Spring Lake Drive, Itasca, IL 60143-3201, in the Accident Prevention Manual for In- dustrial Operations and also in the Safety Data Sheets provided by the NSC. Please also refer to the American National Standards Institute ANSI 01.1 Safety Require- ments for Woodworking Machinery and the U.S. Depart- ment of Labor OSHA 1910.213 Regulations.

3