ASSEMBLING
CUTTINGHEAD
TO TRACK ARM
1.Raise the track arm assembly (A) Fig. 7, by turning overarm elevating handle (F) Fig. 2.
2.Remove packing material from around cuttinghead assembly (B) Fig. 7.
3.Push track arm clamp lever (C) Fig. 7, to the rear until it rests against stop (D) as shown.
4.Pull out on track arm index knob (E) Fig. 7, and rotate track arm (F) 90 degrees to the position shown in Fig. 8. Tighten track arm clamp lever (C) Fig. 8, by pulling it to front position.
5.Unscrew and remove blade guard clamping rod (G) Fig. 9, and remove blade guard assembly (H).
6.Place cuttinghead clamp (J) Fig. 10, in slot on top of cuttinghead. NOTE: Jaws of cuttinghead clamp must be open as shown.
7.Lift cuttinghead assembly (B) Fig. 11, and insert roller bearings (K) into track arm assembly (A) as shown. NOTE: Make certain the roller bearings (K) are riding on track rods (L). Push cuttinghead assembly (B) Fig. 11, into track arm assembly (A) and tighten cuttinghead clamp (J) Fig. 11.
J
Fig. 10
C
F
E
D
A
B
Fig. 7
C
F
Fig. 8
G
H
Fig. 9
A
J
B
L K L
Fig. 11
8
