ADJUSTING BLADE SQUARE WITH TABLE TOP
The saw blade must be square with the table top in order to produce accurate work. To check if the blade is square with the table:
1.DISCONNECT TOOL FROM POWER SOURCE.
2.Remove the blade guard and place the cuttinghead in a
3.Place a steel square (A) Fig. 42, against saw blade
(B) and table, and check to see if the blade (B) is square with the table. Make certain the square is between the teeth of the saw blade.
4.If the blade is not square with the table an adjustment is necessary. Loosen two bolts (C) Fig. 43.
5. Loosen screw (D) Fig. 44, located inside of yoke (E).
6.Hold cuttinghead with left hand as shown in Fig. 45, loosen bevel clamp handle (F) and tilt the motor until the saw blade is flush against the square.
A
B
Fig. 42
C
Fig. 43
E
D
Fig. 44
F
Fig. 45
17
