Denon AVR-3802 manual Last Function Memory, Initialization of the Microprocessor

Recalling preset stations

•To call out preset stations from the remote control unit.

1	ENTER	Watching the display, press the
		SHIFT button to select the preset
	SHIFT	memory block.
	(Remote control unit)
2	CHANNEL	Watching the display, press the
		CHANNEL + (UP) or – (DOWN)
	+
		button to select the desired preset

SKIP

channel.

-

SKIP

(Remote control unit)

•Calling out preset stations from the main unit‘s panel.

1	TUNING	Press the TUNING PRESET button.
	PRESET

(Main unit)

2 FUNCTION Turn the FUNCTION knob and

select the desired station.

(Main unit)

	TV	CD CDR/MD/ TAPE RECEIVER
	VCR	DBS/CABLE	VDP	DVD
	DISPLAY		MENU
	SURR.			OSD
	PARA.
	SETUP			RETURN
		TUNING		A/B
				MEMORY
		BAND	MODE
	CHANNEL			VOLUME
	+	TUNING		+
2
	SKIP	ENTER
	-			1
		SHIFT		-
	SKIP	MUTING

1 2

B

13LAST FUNCTION MEMORY

•This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately before the power is switched off.

This function eliminates the need to perform complicated resettings when the power is switched on.

•The unit is also equipped with a back-up memory. This function provides approximately one week of memory storage when the main unit’s power switch is off and with the power cord disconnected.

14INITIALIZATION OF THE MICROPROCESSOR

When the indication of the display is not normal or when the operation of the unit does not shows the reasonable result, the initialization of the microprocessor is required by the following procedure.

1	Switch off the unit and remove the AC cord from the wall
	outlet.
2	Hold the following AUTO button and PCM button, and plug
	the AC cord into the outlet.
3	Check that the entire display is flashing with an interval of

about 1 second, and release your fingers from the 2 buttons and the microprocessor will be initialized.

B

1 2

NOTES:

•If step 3 does not work, start over from step 1.

•If the microprocessor has been reset, all the button settings are reset to the default values (the values set upon shipment from the factory).

62