2INTRODUCTION
Thank you for choosing the DENON
As this product is provided with an immense array of features, we recommend that before you begin hookup and operation that you review the contents of this manual before proceeding.
TABLE OF CONTENTS
z Before Using | 4 |
x Cautions on Installation | 4 |
c Cautions on Handling | 5 |
v Features | 5 |
b Connections | 6~15 |
n Part Names and Functions | 16, 17 |
m Setting up the system | 18~30 |
, Remote Control Unit | 31~39 |
. Operation | 39~45 |
⁄0Surround | 46~52 |
⁄1DENON Original Surround Modes | 53~56 |
⁄2Listening to the Radio ……………………………………………………57~59 | |
⁄3Last Function Memory | 59 |
⁄4Initialization of the Microprocessor.…………………………………………59 | |
⁄5Troubleshooting..………………………………………………………………60 | |
⁄6Additional Information ……………………………………………………61~68 | |
⁄7Specifications .…………………………………………………………………69 | |
2ACCESSORIES
Check that the following parts are included in addition to the main unit:
q Operating instructions…..1 | w Warranty ( for North America model only )………...........1 | e Service station list…….....1 | r AC cord.................……1 | ||||
t Remote control unit | y R6P/AA batteries….....2 | u AM loop antenna…...1 | i FM indoor antenna…........1 | o FM antenna adaptor….1 | |||
|
|
|
|
|
|
| |
r | t |
|
| y | u | i | o |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1 BEFORE USING
Pay attention to the following before using this unit:
•Moving the set
To prevent short circuits or damaged wires in the connection cords, always unplug the power cord and disconnect the connection cords between all other audio components when moving the set.
•Before turning the power switch on
Check once again that all connections are proper and that there are not problems with the connection cords. Always set the power switch to the standby position before connecting and disconnecting connection cords.
2 CAUTIONS ON INSTALLATION
Noise or disturbance of the picture may be generated if this unit or any other electronic equipment using microprocessors is used near a tuner or TV.
If this happens, take the following steps:
•Install this unit as far as possible from the tuner or TV.
•Set the antenna wires from the tuner or TV away from this unit’s power cord and input/output connection cords.
•Noise or disturbance tends to occur particularly when using indoor antennas or 300 Ω /ohms feeder wires. We recommend using outdoor antennas and 75 Ω /ohms coaxial cables.
For heat dispersal, leave at least 10 cm of space between the top, back and sides of this unit and the wall or other components.
•Store this instructions in a safe place.
After reading, store this instructions along with the warranty in a safe place.
•Note that the illustrations in this instructions may differ from the actual set for explanation purposes.
10 cm or more |
10 cm or more
wall
4
