Denon AVR-788 Playback, BAND, BAND, SHIFT, [OFF], SHIFT, [MODE, [MODE, TUNING, PRESET, <POWER, ENGLISH, CHANNEL, [TUNER], <PHONES, [TUNER], [MUTING], [MEMORY], [ON/SOURCE]

ENGLISH
Getting		SOURCE SELECT	BAND	SHIFT
Getting	<SOURCE> <PHONES>			MASTER VOLUME
Started
Connections
Setup		<POWER>	PRESET CHANNEL
Playback		<POWER>	PRESET CHANNEL
	<ON/STANDBY> <SPEAKER>			TUNING
	[Front]
Remote	[Front]	[OFF]
		[OFF]		[ON/SOURCE]
		SHIFT		[ON/SOURCE]
		SHIFT		PRESET
	SOURCE SELECT
Control
				CHANNEL
				CHANNEL
				[TUNER]
Zone-Multi				[TUNER]
Zone-Multi				MASTER VOLUME
Information				[MUTING]
Information

Playback

Preparations

Turning the Power On

1Press <POWER>.

The power indicator lights red and the power is set to the standby mode.

2Press <ON/STANDBY> or [ON/SOURCE].

The power indicator flashes green and the power turns on.

Turning the Power Off

qPress <ON/STANDBY> or [OFF].

The power is set to the standby mode. wPress <POWER>.

The power indicator turns off, and so does the power.

NOTE

Power continues to be supplied to some of the circuitry even when the power is in the standby mode. When leaving home for long periods of time or when traveling, either press <POWER> to turn off the power, or unplug the power cord from the power outlet.

Operation on the remote control unit

Set [MODE SELECTOR 1] to “AUDIO” then press [SOURCE SELECT].

The desired input source can be selected directly.

Operations During Playback

Adjusting the Master Volume

Either turn <MASTER VOLUME> or press [MASTER VOLUME].

Turning Off the Sound Temporarily (Muting)

Press [MUTING].

To cancel, press [MUTING] again. Muting can also be canceled by adjusting the master volume.

Listening with Headphones

Plug the headphones into <PHONES>.

The sound from the speakers and pre-out connectors is automatically cut.

	[MODE	[MODE
Troubleshooting	SELECTOR 1]	SELECTOR 2]
	[Rear]	[TUNER]
		[TUNER]
	SOURCE SELECT

TUNING [MODE]

NOTE

	Selecting the input source	Be careful not to set the volume too high when using headphones.
	Selecting the input source
Operation on the main unit		Switching the front speakers

		Press <SPEAKER>.
	Turn <SOURCE SELECT>.	Press <SPEAKER>.
	Turn <SOURCE SELECT>.

If “Rec Select” is selected for the input source, press <SOURCE> before turning <SOURCE SELECT>.

[MEMORY]

BAND

About the button names in these explanations

<> : Buttons on the main unit

[ ] : Buttons on the remote control unit

Button name only:

Buttons on the main unit and remote control unit