Denon AVR-788 Remote Control Unit Operations, [MODE, [MODE, ENGLISH, [NUMBER], [NUMBER], [MAIN ON], Components, Presetting, SELECTOR 1], [ZONE2 OFF], [MODE SELECTOR 2]

Remote Control Unit Operations

[Front]

[MODE	[MODE
SELECTOR 1]	SELECTOR 2]

[Rear]

[ZONE2 OFF] [MAIN ON][NUMBER]

Depending on the model and year of manufacture of your equipment, some buttons may not operate.

Operating DENON AudioComponents1Set [MODE SELECTOR 1] to “AUDIO”.

2Set [MODE SELECTOR 2] to the position for the component to be operated (CD, iPod/NETWORK or TAPE/CD-R/MD).

3Operate the audio component.

b For details, refer to the component’s operating instructions.

b While this remote control is compatible with a wide range of infrared controlled components, it may be the case that some component models cannot be operated with this remote control.

Presetting

•DENON and other makes of components can be operated by setting the preset memory.

•This remote control unit can be used to operate components of other manufacturers without using the learning function by registering the manufacturer of the component as shown in the list of preset codes (vEnd of this manual).

•Operation is not possible for some models.

1Set [MODE SELECTOR 1] to “AUDIO” or “VIDEO”.

b Set to the AUDIO side for the CD or TAPE/CD-R/MD position, and to the VIDEO side for the DVD/VDP, SAT/CABLE, VCR or TV position.

2Set [MODE SELECTOR 2] to the component to be registered.

3Press [ZONE2 OFF] and [MAIN ON] at the same time. The indicator starts flashing.

4Referring to the included list of preset codes, press [NUMBER] to input the preset code (a 3-digit number) for the manufacturer of the component whose signals you want to store in the memory.

5To store the codes of another component in the memory, repeat steps 1 to 4.

ENGLISH

	• The signals for the pressed buttons are emitted while setting the			Getting

	preset memory. To avoid accidental operation, cover the remote			Started
	• Depending on the model and year of manufacture, this function
	control unit’s transmitting window while setting the preset memory.
	cannot be used for some models, even if they are of makes listed in			Connections
	verify correct operation.
	the list of preset codes.
	• Some manufacturers use more than one type of remote control code.
	Refer to the included list of preset codes to change the number and
	• The preset memory can be set for one component only among the			Setup
	following: TAPE/CD-R/MD, DVD/VDP and SAT/CABLE.

				Playback
	Operating Preset Components

	1Set [MODE SELECTOR 1] to “AUDIO” or “VIDEO”.
				Remote
	b Set to the AUDIO side for the CD or TAPE/CD-R/MD position,
	and to the VIDEO side for the DVD/VDP, SAT/CABLE, VCR or TV			Control

	position.

	Set [MODE SELECTOR 2] to the component you want			-Multi
	2to operate.
				Zone
	3Operate the component.
				Information
	b For details, refer to the component’s operating instructions.

	b Some models cannot be operated with this remote control unit.
				Troubleshooting