1Either turn <SOURCE SELECT> or press [SAT TU] to select “XM”.
2Press STATUS until “SIGNAL” appears on the display.
The display will switch as shown below, depending on the reception conditions.
Display | Status |
GOOD | Signal strength is good |
MARGINAL | Signal strength is marginal |
WEAK | Signal strength is weak |
NO | No signal |
3Adjust the position of the antenna until “SIGNAL: GOOD” is shown on the display.
4Press STATUS until the station you want to check (example: “XM001”) is displayed.
5Press TUNING and select channel 0 (XM000). The radio ID is shown on the display.
XM000 RADIO ID 
Radio ID
The strength of both the XM satellite and terrestrial signals can be checked at menu “Input Setup” – “Antenna Aiming” (vpage 34).
| Searching Categories |
|
1Press op. | Channel category |
CAT: Rock |
2Use opto select the category, then use uito select the desired station.
The music on an iPod can be played by using the Control Dock for iPod
The operation can also be performed using the buttons on the main unit or remote control unit while watching the menus.
iPod is a trademark of Apple Inc., registered in the U.S.
and other countries.
b The iPod may only be used to copy or play contents that are not copyrighted or contents for which copying or playback is legally permitted for your private use as an individual. Be sure to comply with applicable copyright legislation.
Basic Operation
1Make the necessary preparations.
qSet the iPod in the DENON Control Dock for iPod.
(vSee the Control Dock for iPod’s operating instructions.) wAssign the Control Dock for iPod’s input.
MENU : ”Input Setup” – “Assign” – ”iPod dock”
(vpage 33)
2Either turn <SOURCE SELECT> or press [iPod] to select the input source assigned in step
OK to disconnect.
(iPod screen)
bIf the screens above are not displayed, the iPod may not be properly connected. Try connecting again.
3Set [MODE SELECTOR 1] to “AUDIO” and [MODESELECTOR 2] to “iPod/NETWORK”.
(vpage 48 “Remote Control Unit Operations”)
ENGLISH
• With the default settings, the iPod can be used connected to the VCR | Getting | |
(iPod) connector. | ||
Started | ||
• Use the RESTORER mode to expand the low and high frequency | ||
components of compressed audio files and achieve a richer sound. | ||
The default setting is “Mode3”. | Connections | |
• Press <ON/STANDBY> and set the | ||
mode before disconnecting the iPod. Also switch the input source | ||
to one to which the menu “iPod dock” is not assigned before | ||
disconnecting the iPod. |
NOTE | Setup | |
• Depending on the type of iPod and the software version, some | ||
functions may not operate. |
| |
Playback | ||
• DENON will accept no responsibility whatsoever for any loss of iPod | ||
| ||
data. |
| |
|
| |
| Control Remote | |
| ||
| Information | |
| Troubleshooting |