Denon AVR-788 Other Operations and Functions, <ENTER, <ENTER, ENGLISH, [CH SELECT], [CH SELECT], Channel Level, <SOURCE SELECT, <SOURCE SELECT, Fader Function

Channel Volume

Other OperationsRecording on an External Device (REC OUT mode)

You can listen to one program source while recording a different program source.

1Press <ZONE2/REC SELECT>.

“ZONE2 SOURCE” is shown on the display.

ZONE2 SOURCE ZONE2 TUNER ···· ZONE2 XM

RECOUT XM ······ RECOUT TUNER RECOUT SOURCE

2Turn <SOURCE SELECT> until “RECOUT SOURCE” is displayed.

The “” indicator lights.

3Turn <SOURCE SELECT> to choose the input source to be recorded.

4Play the program source.

For operating instructions, refer to the respective equipment’s operating instructions.

To record FM or AM broadcasts, select the broadcast (vpage 42).

5Start recording.

For operating instructions, refer to the respective equipment’s operating instructions.

•To cancel, press <ZONE2/REC SELECT>, then turn <SOURCE SELECT> until “ZONE2 SOURCE” is displayed.

•Make a test recording before starting the actual recording.

•Sources selected with the REC OUT mode are output from ZONE2 as well.

•In the REC OUT mode, the remote control unit’s ZONE2 mode buttons cannot be operated.

•The “XM” digital audio output signals are not output from the OPTICAL2 output connectors.

•The source selected for MAIN ZONE is output from the digital output connector (OPTICAL 2).

The source selected in the REC SELECT mode is not associated with the output from the digital output connector (OPTICAL 2).

NOTE

•Digital signals are not output from the analog REC OUT connector.

•Recordings you make are for your personal enjoyment and should not be used for other purposes without permission of the copyright holder.

•Input sources for which “Delete” is selected at “Source Delete” cannot be selected.

Convenient FunctionsChannel Level

You can adjust the channel level either according to the playback sources or to suit your taste, as described below.

1Press <ENTER> or [CH SELECT].

Fader

FRONT : REAR

2Use ui, <ENTER> or [CH SELECT] to select the speaker.

The speaker that can be set switches each time one of the buttons is pressed.

3Use o p to adjust the volume.

b “OFF” can be set by pressing o when the subwoofer’s volume is set to –12 dB.

ENGLISH

Fader Function

This function lets you adjust (fade) the sound from all the front or rear speakers at once.

1Press <ENTER> or [CH SELECT].

2Press ui, <ENTER> or [CH SELECT] to select “Fader”.

3Use o p to adjust the volume of the speakers. (o: front, p: rear)

•The fader function does not affect the subwoofer.

•The fader can be adjusted until the volume of the speaker adjusted to the lowest value is –12 dB.

Troubleshooting Information Zone-Multi Control Remote Playback Setup Connections Started Getting