XM connector

 

Antenna terminals

Getting

•The AVR-988 is an XM Ready® receiver. You can receive XM® Satellite Radio by connecting to the XM Mini-Tuner and Home Dock (includes home antenna, sold separately) and subscribing to the XM service.

•Plug the XM Mini-Tuner and Home Dock into the XM connector on the rear panel.

•Position the Home Dock antenna near a south-facing window to receive the best signal.

For details, see “Listening to XM Satellite Radio Programs” (vpage 45, 46).

When making connections, also refer to the operating instructions of the XM Mini-Tuner and Home Dock.

XM Mini-Tuner and Home Dock

XM

An F-type FM antenna cable plug can be connected directly.

Direction of broadcasting station

 

FM antenna

AM loop antenna

(supplied)

 

75 Ω/ohms Coaxial cable

FM indoor antenna

(supplied)

 

 

Connection of AM antennas

 

 

1. Push the

2. Insert the

3. Return the

Ground

AM outdoor antenna

lever.

conductor.

lever.

 

 

 

 

 

 

 

AM loop antenna assembly

Connect to the AM antenna terminals.

NOTE

Troubleshooting Information Zone-Multi Control Remote Playback Setup Connections Started

 

Remove the vinyl tie and take

 

out the connection line.

 

a. With the antenna on top of

NOTE

any stable surface.

 

Keep the power cord unplugged until the XM Mini-Tuner and Home

 

Dock connection have been completed.

 

• The XM name and related logo are registered trademarks of XM

Mount

Satellite Radio Inc. All rights reserved.

 

•XM Ready is a registered trademark of XM Satellite Radio Inc. All rights reserved.

Bend in the reverse direction.

b. With the antenna attached to a wall.

Installation hole Mount on wall, etc.

•Do not connect two FM antennas simultaneously.

•Even if an external AM antenna is used, do not disconnect the AM loop antenna.

•Make sure the AM loop antenna lead terminals do not touch metal parts of the panel.

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

18