Checking the XM Signal Strength and Radio ID

1Either turn <SOURCE SELECT> or press [SAT TU] to select “XM”.

2Press <STATUS> until “SIGNAL” appears on the display.

The display will switch as shown below, depending on the reception conditions.

Display

Status

GOOD

Signal strength is good

MARGINAL

Signal strength is marginal

WEAK

Signal strength is weak

NO

No signal

3Adjust the position of the antenna until “SIGNAL: GOOD” is shown on the display.

4Press <STATUS> until the station you want to check (example: “XM001”) is displayed.

5Press [TUNING] and select channel 0 (XM000). The radio ID is shown on the display.

Radio ID

The strength of both the XM satellite and terrestrial signals can be checked at menu “Input Setup” – “Antenna Aiming” (vpage 36).

Searching Categories

1Press op.

Channel category

2Use opto select the category, then use uito select the desired station.

Troubleshooting Information Zone-Multi Control Remote Playback Setup Connections Started Getting

46