Denon AVR-988 manual 22

Troubleshooting Information Zone-Multi Control Remote Playback Setup Connections Started Getting

Multi-zone			External Controller
ZONE2 Pre-out Connections
• If another power amplifier or pre-main (integrated) amplifier is connected, the ZONE2 pre-out (variable or					RS-232C connector
fixed level) connectors can be used to play a different program source in ZONE2 the same time (vpage
55 ~ 58).				This connector is used for an external controller.
• When using an S-Video cable or a video cable for connection between the AVR-988 and an input device,
connect to the video connectors.				b If	you wish		to control		the	AVR-988	from
	Power amplifier			an	external		controller using			the RS-232C
Monitor (ZONE2)				connector,		perform		the	operation		below
	(ZONE2)
				beforehand.
7*%&0	"6%*0
				q Turn om the AVR-988’s power.
7*%&0	"6%*0
*/		*/		w Turn off the AVR-988’s power from the external
	-	3		controller.
				e Check that the AVR-988 is in the standby
				mode.
	L	R
			• When using in combination with an RF Remote Controller (RC-7000CI, sold separately) or RF Remote
	L	R	Receiver (RC-7001RCI, sold separately) two-way communication			with an		RF Remote Controller is
			possible.
			The AVR-988’s status information as well as iPod	can be browsed watching the RF Remote Controller’s
			display. For details, refer to the operating instructions of the respective devices.
			• When used in combination with an RF Remote Controller or RF Remote Receiver, make the settings at
			menu “Manual Setup” – “Option Setup” – “2Way Remote” – “Used” (vpage 32).

				Trigger output jacks
				The power of an external device equipped with
				a trigger input jack can be turned on and off in
				association with operations on the AVR-988. For
"69	Input	Output		details, see menu “Manual Setup” – “Option
065				Setup” – “Trigger Out” (vpage 32).
Infrared		Infrared
			Extension jack for future use.	• Output: DC 12 V 150 mA MAX.
retransmitter		sensor
				Check the trigger input conditions of the
				connected device.

NOTE

•For the audio output, use high quality pin-plug cords so that no induction humming or noise is produced.

•For instructions on installing and operating separately sold devices, refer to the respective devices’ operating instructions.

•To conduct multi-zone playback, see “Amp Assign / Multi-zone Connections and Operations” (vpage 55 ~ 58).

19