Fireplace
Installation
Continued
placing the positioning tabs on the glass frame into the slots in the retaining bracket then swinging the door into the sealed position and locking the two latches in place.
7.Replace the top louver panel and then the lower louver panel.
UNLOCK |
| Glass Door |
| LOCK | Panel |
|
| |
Latch |
|
|
Door Frame Tab
Figure 45 - Removing/Replacing Glass
Door
Installing LOGS, lava rock and glowing embers
A 4 piece ceramic log set comes packed inside the unit firebox. Removal of glass door is necessary to unpack and assemble the logs and add hearth treat- ments. Follow steps under Removing/Replacing Glass Door, page 25 to access the logs and burner. Assemble the logs and add burner treatments as follows:
1.Position the base log onto burner log mounts (see Figure 46). Note: The cut out on the bot- tom should fit over the mounts and the base log should be positioned against the rear panel.
2.Position the holes on the bottom of the rear log over the pins on the base log Figure 46).
3.Position the top left log and top right log onto the rear log and base log as shown in (see Figure 46).
WARNING: The glass door must be securely in place before running this fireplace. Do not run this fireplace if glass is missing or broken.
4.Open the bag of ember materials.
5.Break apart about quarter sized pieces and place about a single layer along the full length of the ember tray to hide the bottom edge of the base log (see Figure 47).
6.Replace the glass door and louver panels. See
Removing/Replacing Glass Door, page 25.
Top Left | Top | |
Right | ||
Log | ||
Log | ||
|
Rear
Log
Front
Log 
Rear Log
Stand
Burner
Pan
Log Mounts
Figure 46 - Installing Logs
Ember 
Material
Ember
Tray
Figure 47 - Applying Ember Material
www.desatech.com | 27 |
