Installing Optional Blower Accessory GA3450TA

INSTALLATION

Optional Mantel Installation (Cont.) Installing Optioanl Blower Accessory GA3450TA

INSTALLATION

Continued

13.Check for leaks. See Checking Gas Connections, page 16.

14.Place mantel around fireplace. Be careful not to damage wall or mantel.

15.Place perimeter trim kit on the shoulder screws located on the side and top of the fireplace. Firmly snap trim over shoulder screws on fireplace (see Figure 12).

16.Adjust assembly to remove any gaps. Attach remaining two 3" wood screws from hardware pack through openings inside of fireplace sides into the mantel. The openings are located at top behind the area for top louver (see Figure 12).

17.Reinstall top louver.

Assembling Perimeter Trim (Perimeter trim shipped with mantel)

1.Remove packaging from three remaining pieces of trim.

2.Locate two adjusting plates with set screws, and two shims in the hardware packet.

3.Align shim under adjusting plate as shown in Figure 13.

4.Slide one end of adjusting plate/shim in slot on mitered edge of top brass trim (see Figure 13).

5.Slide other end of adjusting plate/shim in slot on mitered edge of side perimeter trim (see Figure 13).

6.While firmly holding edges of perimeter trim together, tighten both set screws on the adjusting plate with slotted screwdriver.

7.Repeat steps 1 through 6 for other corner.

8.Set perimeter trim assembly aside for later installation.

Set

Screws