Optional Remote Control Accessories, Local Codes, Unpacking

OPTIONAL REMOTE CONTROL ACCESSORIES

4 LOCAL CODES PRODUCT FEATURES UNPACKING

HOOD ASSEMBLY

OPTIONAL REMOTE CONTROL ACCESSORIES

(For Remote-Ready Models Only)

There are four optional remote controls that can be purchased separately for Remote-Ready Models only:

•	wall switch	•	hand-held ON/OFF remote
•	wall thermostat	•	hand-held thermostat remote

See Accessories, pages 36 and 37.

LOCAL CODES

Install and use fireplace with care. Follow all local codes. In the absence of local codes, use the latest edition of The National Fuel Gas Code ANSI Z223.1/NFPA 54*.

*Available from:

American National Standards Institute, Inc.

1430 Broadway

New York, NY 10018

National Fire Protection Association, Inc.

Batterymarch Park

Quincy, MA 02269

PRODUCT FEATURES

SAFETY PILOT

This fireplace has a pilot with an Oxygen Depletion Sensing (ODS) safety shutoff system. The ODS/pilot is a required feature for vent-free room fireplaces. The ODS/pilot shuts off the fireplace if there is not enough fresh air.

PIEZO IGNITION SYSTEM

This fireplace has a piezo ignitor. This system requires no matches, batteries, or other sources to light fireplace.

THERMOSTATIC HEAT CONTROL FOR THERMOSTAT-CONTROLLED MODELS

Thermostat-Controlled models have a thermostat sensing bulb and a control valve. The thermostat will automatically modulate the heat output to maintain a consistent room temperature. This results in greater fireplace comfort. This can also result in lower gas bills.

UNPACKING

1.Remove fireplace and hood from carton. Log is wrapped and inside fireplace. Do not remove at this time.

2.Remove all protective packaging applied to fireplace for shipment.

3.Make sure your fireplace includes one hardware packet.

4.Check fireplace for any shipping damage. If fireplace is dam- aged, promptly inform dealer where you bought fireplace.

HOOD ASSEMBLY

WARNING: Always have screen in place before operating fireplace. This prevents excessive tem- peratures on fireplace surfaces.

WARNING: Failure to position the parts in accor- dance with these diagrams or failure to use only parts specifically approved with this fireplace may result in property damage or personal injury.

Tools Required:
•	Phillips screwdriver	•	slotted screwdriver
•	5/16" hex wrench	•	scissors

1.Lift fireplace screen up and pull out to remove (see Figure 2). Set screen aside until installation has been completed.

2.Cut two plastic straps to remove the log from the firebox cavity. Set log aside.

3.An optional blower is available. See Accessories, pages 36 and 37. Install optional blower now. Follow installation instruc- tions provided with blower and see page 12 for Remote-Ready Models or page 13 for Thermostat-Controlled Models.

4.Locate four black phillips sheet metal screws in hardware packet.

5.Slide hood between louver and firebox top and align screw holes.

6.Insert screws as shown in Figure 3. Tighten screws firmly.

Shoulder Screw

Screen

Figure 2 - Removing and Installing Screen