Desa VDCFRP, CDCFTN Optional Wireless Hand-Held Remote Control Accessories, Installing Receiver

INSTALLATION

Optional Wireless Hand-Held Remote Control Accessories [Remote-Ready Models Only]

17

INSTALLATION

Continued

OPTIONAL WIRELESS HAND-HELD REMOTE

CONTROL ACCESSORIES

Remote-Ready Models Only

([C]GHRCB Series & [C]GHRCTB Series)

Installing Receiver

1.Disconnect wires from the control valve (see Figure 26) .

2.Locate the battery clip mounted on the back of the receiver (see Figure 27).

3.Slide 9-volt battery (not included) through the clip.

4.Attach the terminal wires to the battery (see Figure 27).

5.Connect wires from remote receiver to control valve as shown in Figure 28.

6.Install remote receiver unit onto remote/blower bracket using screws provided (see Figure 28).

I

H

LO

	O
	F
N	F
O
	I P
	TOL

Figure 26 - Disconnecting Wires From Control Valve

Receiver

Installing 9-Volt Battery in Hand-Held Remote Control Unit

1.Remove battery cover on back of remote control unit.

2.Attach terminal wires to the battery (not included). Place bat- tery into the battery housing.

3.Replace battery cover onto remote control unit.

Terminal	Battery Cover
	Remote
Wires
	Control Unit
9-Volt
Battery

Battery

Housing

Figure 29 - Installing Battery in Hand-Held Remote Control Unit (GHRCB and CGHRCB Series)

Terminal Wires

9-Volt	Remote
Battery
	Control Unit
Battery	Battery Cover
Housing

Figure 30 - Installing Battery in Hand-Held Remote Control Unit

(GHRCTB and CGHRCTB Series)

Terminal

Wires

9-Volt Battery

Battery Clip

Figure 27 - Attaching Battery to Receiver

White Wire to

TH Terminal on

Control Valve

Remote

Receiver

Red Wire to TPTH

Terminal on Control

Valve

Figure 28 - Installing Remote Receiver

For morevisit www..com

111244-01A