Desa LFP33PRA Installing Batteries For Cghrc And Cghrct Series, Installation, Continued

OWNER’S MANUAL

INSTALLATION

Continued

OPTIONAL WIRELESS HAND- HELD REMOTE CONTROL ACCESSORY CGHRC and

CGHRCT SERIES

Installing Remote Receiver Unit

1.Disconnect switch wires from the con- trol valve.

2.Remove screws attaching switchplate.

3.Remove switch plate (see Figure 32). Discard after removing.

4.Install remote receiver unit onto gas log heater base using mounting clips.

5.Push clips firmly into place (see Fig- ure 33).

6.Connect wires as shown in Figure 34.

Remote Switch	Ignitor
Bracket

Screw

Switch Plate Wires

Figure 32 - Switch Plate and Wiring Harness

Mounting

Clips

Remote Receiver

Figure 33 - Installing Remote Receiver

White Wire

From Receiver

Valve

Red Wire From

Receiver

Figure 34 - Connecting Wires

INSTALLING BATTERIES FOR CGHRC AND CGHRCT SERIES

Two 9-volt batteries (not included) are re- quired to operate this heater with the wire- less hand held remote control set. Install one battery in the receiver and one in the hand- held remote control unit. Note: Only use alkaline batteries.

Installing Battery in Receiver

1.Locate back of receiver under front burner of heater.

2.Locate the battery clip mounted on the back of the receiver.

3.Slide a 9-volt battery through the clip.

4.Attach the terminal wires to the battery.

Remote

Receiver

Terminal Wires

Battery Clip

9-Volt Battery

Figure 35 - Installing Battery in Remote Receiver

Installing Battery in Hand-Held Remote Control Unit

1.Remove battery cover on back of re- mote control unit.

2.Attach terminal wires to the battery. Place battery into the battery housing.

3.Replace battery cover onto remote con- trol unit.

	Battery	Remote
Terminal		Control Unit
	Cover
Wires
9-Volt
Battery

Battery

Housing

Figure 36 - Installing Battery in Hand- Held Remote Control Unit

107064 15