Desa LMFP33PR(A) BUILT-IN Fireplace Installation, Inserting Fireplace Into Cabinet Mantel

INSTALLATION

Continued

Figure 12 - Inserting Fireplace Into

Cabinet Mantel

BUILT-IN FIREPLACE

INSTALLATION

Built-in installation of this fireplace involves installing fireplace into a framed-in enclosure. This makes the front of fireplace flush with wall. If installing a mantel above the fireplace, you must follow the clearances shown in Figure 18, page 13. Follow the instructions below to install the fireplace in this manner.

	Actual	Framing
Height	32 3/8"	33"
Front Width	34 5/16"	35 1/8"
Depth	16 11/16"	17 3/4"

WARNING: A qualified electri- cianmustconnectelectricalwiring to duplex outlet for built-in instal- lation. Follow all local codes.

1.Frame in rough opening. Use dimensions shown in Figure 13 for the rough opening. If installing in a corner, use dimensions shown in Figure 14 for the rough opening. The height is 33" which is the same as the wall opening above.

2.If using blower, install duplex outlet to the right support bracket in the bottom of firebox (see Figure 15). See Accessories, page 34. If not using blower, go to step 7.

3.Route wires from electrical box through smallest hole in outer casing using strain relief fitting provided (see Figure 15).

4.Connect wires from the electrical box to duplex outlet. Match wire colors to those indicated on duplex outlet. Be sure to connect ground wire.

5.Install shield to end of right support bracket and behind the firebox wrapper with 2 screws provided (see Figure 16, page 12).

6.Plug blower cord into duplex outlet.

7.Replace bottom of firebox and reconnect remote receiver module to valve.

17 3/4"

33"

35 1/8"

Figure 13 - Rough Opening for Installing

in Wall

393/8"

27 7/8"

35 1/8" 55 5/8"

Figure 14 - Rough Opening for Installing

in Corner

Blower	Blower	Cable from
Power Cord
		Electrical Source

Duplex

Outlet

Support

Bracket

Strain

Relief

Fitting

Screw

Figure 15 - Connecting Duplex Outlet

111604-01L www.desatech.com 11