Local Codes, Unpacking, Product Features

LOCAL CODES

Install and use ﬁreplace with care. Follow all local codes. In the absence of local codes, use the lat- est edition of The National Fuel Gas Code ANSI Z223.1/NFPA 54*.

*Available from:

American National Standards Institute, Inc.

1430 Broadway

New York, NY 10018

National Fire Protection Association, Inc.

Batterymarch Park

Quincy, MA 02269

Note: Where listed vented decorative logs are required, thermostat operation is not permitted.

UNPACKING

CAUTION: Do not remove the dataplatesattachedtotheheater base assembly. The data plates contain important warranty and safety information.

1.With utility knife, cut the carton all the way around above the staples on the bottom tray. Lift the carton off the heater. Remove packing. Note: The hood is located in the packing on the right hand side of the heater front. Lift the heater off the bottom tray.

2.Locate two screws above top corners of the ﬁreplace screen. Remove and discard these screws. Lift ﬁreplace screen up and pull out to remove.

3.Remove protective packaging applied to logs, log base assembly and ﬁreplace.

4.Remove ﬁreplace hood from carton insert.

5.Check all items for any shipping damage. If damaged, promptly inform dealer where you bought ﬁreplace.

PRODUCT FEATURES

OPERATION

This vent-free ﬁreplace is clean burning. It requires no outside venting. There is no heat loss out a vent or up a chimney. Heat is generated by both realistic ﬂames. When used without the blower, the ﬁreplace requires no electricity making it ideal for emergency backup heat. This heater is designed for vent-free operation. It has been tested and ap- proved to ANSI Z21.11.2 standard for unvented heaters. State and local codes in some areas pro- hibit the use of vent-free heaters.

SAFETY DEVICE

This ﬁreplace has a pilot with an Oxygen Depletion Sensing (ODS) safety shutoff system. The ODS/ pilot is a required feature for vent-free room heat- ers. The ODS/pilot system shuts off the ﬁreplace if there is not enough fresh air.

PIEZO IGNITION SYSTEM

This ﬁreplace has a piezo ignitor. This system requires no matches, batteries or other sources to light ﬁreplace.

OPTIONAL BLOWER ASSEMBLY (GA3750 SERIES & GA3650TB

SERIES)

This ﬁreplace accepts an optional blower assembly (not included). The GA3650TB Series blower operates thermostatically and features a variable speed control. The GA3750 Series blower operates manually and also features a variable speed control. The blower circulates heated air from the ﬁreplace into the room. See Accessories, page 34.

AIR FOR COMBUSTION

AND VENTILATION

WARNING: This heater shall not be installed in a conﬁned spaceorunusuallytightconstruc- tion unless provisions are provid- ed for adequate combustion and ventilation air. Read the following instructionstoinsureproperfresh air for this and other fuel-burning appliances in your home.

Todayʼs homes are built more energy efﬁcient than ever. New materials, increased insulation and new construction methods help reduce heat loss in homes. Home owners weather strip and caulk around windows and doors to keep the cold air out and the warm air in. During heating months, home owners want their homes as airtight as possible.

While it is good to make your home energy efﬁ- cient, your home needs to breathe. Fresh air must enter your home. All fuel-burning appliances need fresh air for proper combustion and ventilation.

Exhaust fans, ﬁreplaces, clothes dryers and fuel burning appliances draw air from the house to operate. You must provide adequate fresh air for these appliances. This will insure proper venting of vented fuel-burning appliances.

111604-01L

Desa LMFP33PR(A) Local Codes, Unpacking, Product Features, AIR for Combustion Ventilation

Models: LMFP33PR(A)