OWNER’S MANUAL
CAST IRON STOVE AND
Continued
INSTALLING B-VENT BURNER SYSTEM INTO STOVE BODY
1.Carefully lift burner system and place into stove body from the rear of stove (see Figure 16).
2.Place the left, right, and center grate top into top of stove body.
Burner
Cast Iron System
Stove Body
Figure 16 - Installing Burner System into Cast Iron Stove Body
Center Top Grate (Included with Stove Body)
Left Top Grate | Right |
| |
| Top |
| Grate |
Burner
System
in Stove
Body
INSTALLING OPTIONAL BLOWER ACCESSORY
NOTICE: If installing blower in an existing stove burner system with gas connections, shut off gas sup- ply and disconnect burner sys- tem from gas supply. Contact a qualified service person to do this.
1.Remove 4 hex screws securing rear cover to back of stove body (see Figure 18).
2.Separate bottom cover from rear cover by loosening the 8 mounting screws (see Figure 18).
3.Align the holes in the top mounting tabs of blower with the holes in wall of rear cover. Using the 4 screws provided, mount blower and tighten screws se- curely (see Figure 19).
4.Attach thermal switch and bracket to inside rear cover wall with two hex head screws provided as shown. After secur- ing bracket to rear cover, carefully bend
along existing bend line on bracket to almost a 90° angle (see Figure 19). This will allow thermal switch to be posi- tioned against stove rear wall and sense temperature when in operating mode.
Hex Screws
Stove Body
Locknut
Blower Control
Control Shaft
Knob
TOP VIEW
Speed
Control
Thermal Switch and Bracket
Screws
Mounting
Holes
Blower
Assembly Mounting
Holes
Figure 19 - Blower Assembly, Speed Control, and Thermal Switch Locations
Rear Cover
Mounting
Screws
Hex
Screws
Mounting
Screws
Mounting
Screws
Bottom Cover
Figure 17 - Installing Top Grates
Figure 18 - Removing Rear Cover and Bottom Cover from Stove Body
Continued
106706 | 7 | For more information, visit www.desatech.com |