OWNER’S MANUAL
CAST IRON STOVE AND B-VENT BURNER SYSTEM ASSEMBLY
STOVE BODY ASSEMBLY
1.Lift off corrugated box enclosing stove body crating.
2.Remove all screws fastening the wood frame enclosure. Spread wood frame open and lift away from
3.Remove plastic bag from stove body.
4.Remove back panel from stove and dis- card (see Figure 6). Use an adjustable wrench or a 10 mm socket. Remove six
(6)bolts and washers. Keep bolts and washers to attach rear cover.
5.Remove all contents from inside stove cavity. Contents include:
(1)- Stove bottom (Discard - Not used with this application)
(4)- Legs with leg leveler bolts
(1)- Bottom door
(3)- Top grates
(1)- Hardware kit bag with fasteners
6.Carefully lay stove body on back to at- tach bottom components to stove body (see Figure 7). Rest stove on drop cloth or blanket to avoid scratching stove edges.
7.Remove remaining pallet wood at- tached to bottom of stove body (see Figure 8). Use an adjustable wrench to remove bolts.
8.Fasten each leg to stove with four (4) M8 x 1.25 - 20mm bolts. Use a flat washer and lock washer with each bolt. Tighten bolts into threaded holes on stove body (see Figure 9 and Figure 10, page 6). Use an adjustable wrench or a 12mm socket.
Bolt | Product |
| |
Back | Identification |
Label | |
Stove |
|
Panel |
|
Figure 6 - Removing Back Panel | |
| Top of Stove Unit |
Front of | Front of Stove Unit |
Stove Unit |
|
Drop | Pallet |
Wood | |
Cloth/ | Bolted to |
Blanket | Bottom of |
| Stove Body |
Figure 7 - Laying Down Stove On Side
Bolt | Front | Pallet Wood | ||
|
|
|
|
|
|
|
|
|
|
Bottom Of
Stove Unit
Pallet Wood
Figure 8 - Removing Pallet Wood From The Bottom of The Stove
| Door Catch Bolt With | |
Door Hinge | Adjustable Hex Nuts Hole | |
|
| |
Step Bolt Hole | Front | Leg |
| Hole | |
|
| |
Leg |
|
|
Hole |
|
|
Bottom Of
Stove Unit 
Leg Hole
Figure 9 - Locating Threaded Holes for Legs and Door Attachment
Stove
Unit
Continued
106706 | 5 | For more information, visit www.desatech.com |
