Desa Td125, Td126, Td127, Td128 owner manual Continued, To Light, To Shut Down

Operation

Continued

TO LIGHT

1.Shut main gas supply valve on propane cylinder off. Set heater control knob to OFF position. Wait 5 minutes.

2.Open main gas supply valve on propane cylinder.

WARNING: If you smell gas while in use, immediately press and turn control knob to the OFF position to shut down heater.

3.Turn heater control knob to the PILOT po- sition. Push and hold for 5 seconds. Press igniter button until pilot is lit. Continue to hold heater control valve for 30 seconds then release.

TO SHUT DOWN

1.Turn control knob to the OFF position.

2.Shut off main gas supply.

3.Wait 5 minutes before relighting heater.

CAUTION: Do not attempt to slide viewing hole cover when main burner is lighting, operat- ing or hot.

4.TO MATCH LIGHT PILOT: Rotate match light hole cover. Apply flame to pilot burner while holding knob in for 20 seconds or until pilot remains lit when knob is re- leased.

5.Knob can now be turned to the ON position.

IMPORTANT: Smoke and odor (not a gas odor) emission may occur in the first 30 min- utes of use. Run heater at high setting for at least 30 minutes to eliminate this problem.

Viewing Hole

and Cover

Control

Knob

Ignitor Button

Figure 17 - Heater Controls and Viewing

Hole and Cover

Storage

1.Allow at least 45 minutes for heater to cool down after using.

2.Store heater upright in a sheltered area away from inclement weather and dust.

3.If desired, cover heater after heater has cooled.

4.If heater is not to be used for an extended period of time, disconnect and remove propane/LP gas cylinder and store in ac- cordance with the Standard for Storage and Handling of Liquefied Petroleum Gases, ANSI/INFPA 58.

10 www.desatech.com 121117-01B